CP4709 - Small Diameter Fluid Reservoirs
A small diameter plastic reservoir with central outlet which can be screwed directly into a master cylinder.
Features
- Available in a choice of 3 volumes
- O'ring seal supplied
- Remote or Direct Fit options available
- Copper gasket supplied with all remote use reservoirs with threaded adaptors
- Optional CP2709-156 Bellow available for medium and tall reservoirs to minimise the entry of dirt and moisture
Available Configurations
Instructions for fitting CP4709 Screw Type Reservoirs
- Remove and discard inlet adaptor (Blue or Gold), and copper gasket fitted to the master cylinder and clean thread. fig 1.
- Fit O-Ring seal supplied into groove in reservoir base. fig 2.
- Screw reservoir into master cylinder body until the slack is taken up, then hand tighten a further ½ to ¾ turn, this is sufficient. fig 3.
Note: Optional Reservoir Outlet Adaptors are available for remote use, part numbers details below,
Follow steps 2 & 3 above to fit the following,
CP4709-105 - 7/16" UNF Threaded Outlet Adaptor
CP4709-106 - M12x1 Metric Thread Outlet Adaptor
CP4709-107 - Push-On Type Outlet Adaptor
